Appendix
Appendix
Care
Wipe the base station and handset with a damp cloth (do not use solvents) or an anti- static cloth. Never use a dry cloth. This can cause static.
Contact with liquid !
If the handset should come into contact with liquid, on no account switch the device
on. Remove the battery immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the battery removed in a warm, dry place for at least 72 hours. In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us 24/7 at
What has happened if … | Possible cause | Possible solution |
|
|
|
… the display is blank? | The handset is not switched on. | Press the "end call" key a for |
| The battery is flat. | about 2 sec. |
|
| Charge or replace the battery |
|
| |
… the handset fails to respond | The keypad lock is activated. | Press the hash key R for |
to a key press? |
| about 2 sec. to deactivate the |
|
| lock (page 10). |
… "Base station x" flashes in | The handset is outside the range | Move the handset nearer to the |
the display? | of the base station. | base station. |
| The base station is not switched |
|
| on. | Check the power connector at |
|
| the base station (page 7). |
… Base Search flashes in the | The handset is set for Best | Move the handset nearer to the |
display? | Base. But no base station has | base station. |
| been activated or in range. | Check the power connector at |
|
| the base station (page 7). |
… the handset does not ring? | The ringer is switched off. | Activate/deactivate the ringer |
|
| |
… I cannot hear a ringer tone/ | You have changed the telephone | When purchasing a new cord |
dial tone? | cord on your Gigaset. | ensure that it has the correct |
|
| pin connections (page 7). |
… the call units/charges are | There are no metering pulses. | Ask your network provider to |
not displayed? |
| transmit the metering pulses. |
… the other party cannot hear | You have pressed the u (INT) | Switch on the microphone |
me? | key. This mutes the handset. | again (page 19). |
… the incoming call number is | Calling line identification is not | The caller should ask his net- |
not displayed even though | enabled. | work provider to enable the |
CLIP is set? |
| identification of his number |
|
| (CLI). |
78