Simrad HS50 Heading Sensor
If the Sensor unit connector needs to be reconnected to the cable, the wiring for the cable within the Sensor unit connector is as follows:
|
| Sensor Unit | Cable Wire No. | Signal Description |
|
| Connector | ||
|
|
|
| |
|
| Pin no. |
|
|
1 | 4 | Connector housing | Screen | Shield |
|
| |||
|
| 2 | 4 | Transmit |
2 | 3 | 4 | 3 | Receive |
FRONT VIEW |
| 3 | 2 | +24 VDC |
|
| 1 | 1 | Power ground |
Waterproofing the connectors
The Sensor unit connector junction has to be sealed with self- bonding tape and PVC/Vinyl tape for waterproofing.
1Coil the
2Coil at least two layers of PVC/Vinyl tape without stretching as shown in the figure below. After coiling, make a bonding by pressure of fingers.
3.5Display unit
Location of the unit
Avoid mounting the Display unit where it is easily exposed to sunlight, as this will shorten the lifetime of the display. If this is not possible, make sure the unit is always covered with the white protection cover when not used.
The unit is designed for installation in an indoor environment and for operation within the temperature range. The best location is typically in the instrument room or on the bridge mounted close to the Processing unit.
14 | 20221081 / F |
