INSTALLATION
| Data output | ||
| The Processing unit has two individually configurable output | ||
| serial lines. | ||
| On output line Data output 1 two | ||
| lines are available. The signal cables can be connected to both | ||
| terminal block P202 and P203. | ||
| On Data output 2 one | ||
| available. The signal cables are to be connected to terminal | ||
| block P204. | ||
Note! | All six serial lines may be used simultaneously! | ||
| The setup of baud rate, interval between NMEA sentences and | ||
| output formats for each port are performed in the Data output 1 | ||
| and Data output 2 submenu. | ||
|
|
|
|
|
|
|
|
| Baudrate: | The rate at which bits are transmitted. 4800 is | ||
|
| standard NMEA rate. |
| |
| Interval: | Interval in seconds between | each NMEA | |
|
| sentence. |
| |
|
| Example: |
| |
|
|
|
|
|
|
| Interval setting |
| Hz |
|
|
|
|
|
|
| 1 sec |
| 1 Hz |
|
|
|
|
|
|
| 0.5 sec |
| 2 Hz |
|
|
|
|
|
|
| 0.2 sec |
| 5 Hz |
|
|
|
|
|
|
| 0.1 sec |
| 10 Hz |
|
|
|
|
|
|
| 0.05 sec |
| 20 Hz |
| Format: |
|
| |
| Format on data output line. The following | |||
|
| selections are available: NMEA and none. | ||
| NMEA Format: NMEA sentences to be sent to output line. | |||
WARNING! | If “none” is selected as output format, no data will be | |||
| sent to output line. |
| ||
20221081 / F | 27 |
