![](/images/new-backgrounds/1188845/18884527x1.webp)
Section 3. Installation
Section 3.1 Auto-Setup Module Installation
The
NOTE: | NEVER remove or install any card in the OmniLink 5000 when the power to the |
| control is on. Doing so can damage the control, the card, or both! |
The face plate of the ASM is partitioned with labels such as “SS1", “AS1", etc. These labels represent the type of module that can be installed on the card at that location. “SS1" and “SS2" can have slide adjust modules installed. “AS1" through “AS4" can have air adjust modules (counterbalance and cushion use the same control module) installed. Slide adjust cards are twice the width of air adjust cards. Note that SS2 overlaps with AS1 and AS2 to allow a second slide adjust card to be installed in a double action press at the expense of two air slots. “AS7" is used for hydraulic overload control and is built in to the base card.
Figure 3.1: OmniLink 5000 Extended Card Rack
Each module is held on to the base card by four #6-32 screws. If not already assembled, install each module on the base card putting slide adjust cards in SS1 or SS2 and air adjust cards in AS1, AS2, AS3,
April 17, 2000 Man ual Versio n 1.0 | 3.1 |