![](/images/new-backgrounds/1188845/188845103x1.webp)
Min Position Reached | The slide has gone as low as the min position programmed in the |
| configuration menu and will not be allowed to go lower. |
Moving Up | The slide is moving up. |
Moving Down | The slide is moving down. |
System Off | The slide adjust system is turned off. The slide can still be manually moved |
| by using the jog up and jog down buttons. The slide position will still be |
| shown if the position transducer is still functioning correctly. |
Waiting for | The slide adjust system is waiting for the counterbalance, if present, to come |
| to its correct pressure before automatically moving the slide. |
Slide Too High | The slide is higher than the slide setpoint plus tolerance. |
Slide Too Low | The slide is lower than the slide setpoint minus tolerance. |
Hyd Overload Tripped | The hydraulic overload has tripped. The slide will not move down in this |
| condition. |
| The slide is automatically going to the programmed slide setpoint. |
Waiting for Top | The slide must be at the top of the stroke for automatic positioning to occur. |
| If a job is recalled at the bottom of the stroke, this message will be displayed |
| until the press is at the top. |
| Emergency stop button is depressed. The slide will not automatically move in |
| this condition. |
Waiting S/A Switch | Waiting for the slide adjust switch to be turned on. The slide cannot move |
| while the slide adjust switch is in the off position. |
LMC is Out | The Link Master Control relay is disengaged for some reason (possibly an |
| error at the control). No slide movement may be made while the LMC is |
| tripped. |
April 17, 2000 Man ual Versio n 1.0 | 6.5 |