SMC Networks SMC2552W-G2-17 manual 100

Radio Interface 6

CLI Commands for Radio Settings – From the global configuration mode, enter the interface wireless g command to access the 802.11g radio interface. From the 802.11g interface mode, you can access radio settings that apply to all VAP interfaces. Use the turbo command to enable this feature before setting the radio channel with the channel command. Set any other radio setting as required before enabling the VAP interface (with the no shutdown command). To view the current 802.11g radio settings for the VAP interface, use the show interface wireless g [0~3] command as shown on 7-95.

Enterprise AP(config)#interface wireless g		7-88
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g)#super-g		7-104
Enterprise AP(if-wireless g)#channel	42	7-97
Enterprise AP(if-wireless g)#transmit-power full		7-97
Enterprise AP(if-wireless g)#speed 9		7-96
Enterprise AP(if-wireless g)#antenna	id 0000	7-100
Enterprise AP(if-wireless g)#antenna	control right	7-99
Enterprise AP(if-wireless g)#antenna	location indoor	7-101
Enterprise AP(if-wireless g)#mic_mode hardware		7-120
Enterprise AP(if-wireless g)#super-g		7-104
Enterprise AP(if-wireless g)#beacon-interval 150		7-101
Enterprise AP(if-wireless g)#beacon-interval 150		7-101
Enterprise AP(if-wireless g)#dtim-period 5		7-102
Enterprise AP(if-wireless g)#multicast-data-rate 6		7-96
Enterprise AP(if-wireless g)#fragmentation-length 512		7-102
Enterprise AP(if-wireless g)#rts-threshold 256		7-103
Enterprise AP(if-wireless g)#

6-53