SMC Networks SMC2552W-G2-17 manual General Commands Function Mode

General Commands 7

Table 7-2. Command Groups

Command Group	Description	Page
SNMP	Configures community access strings and trap managers	7-41
Flash/File	Manages code image or access point configuration files	7-56
RADIUS	Configures the RADIUS client used with 802.1X authentication	7-59
802.1X Authentication	Configures 802.1X authentication	7-66
MAC Address	Configures MAC address authentication	7-71
Authentication
Filtering	Filters communications between wireless clients, controls access to the	7-74
	management interface from wireless clients, and filters traffic using
	specific Ethernet protocol types
WDS Bridge	Configures WDS forwarding table settings	7-78
Spanning Tree	Configures spanning tree parameters	7-84
Ethernet Interface	Configures connection parameters for the Ethernet interface	7-89
Wireless Interface	Configures radio interface settings	7-94
Wireless Security	Configures radio interface security and encryption settings	7-110
Rogue AP Detection	Configures settings for the detection of rogue access points in the	7-110
	network
Link Integrity	Configures a link check to a host device on the wired network	7-124
IAPP	Enables roaming between multi-vendor access points	7-128
VLANs	Configures VLAN membership	7-129
WMM	Configures WMM quality of service parameters	7-131

The access mode shown in the following tables is indicated by these abbreviations: Exec (Executive Mode), GC (Global Configuration), IC-E(Interface-Ethernet Configuration), IC-W(Interface-Wireless Configuration), and IC-W-VAP(Interface-Wireless VAP Configuration).

General Commands

Table 7-3. General Commands

Command	Function	Mode	Page
configure	Activates global configuration mode	Exec	7-9
end	Returns to previous configuration mode	GC, IC	7-9
exit	Returns to the previous configuration mode, or exits the CLI	any	7-9
ping	Sends ICMP echo request packets to another node on the	Exec	7-10
	network
reset	Restarts the system	Exec	7-11
show history	Shows the command history buffer	Exec	7-11
show line	Shows the configuration settings for the console port	Exec	7-12

7-7