SMC Networks SMC2552W-G2-17 manual 104

6 System Configuration

CLI Commands for STP Settings – If the role of a radio interface is set to Repeater, Bridge or Root Bridge, STP can be enabled on the access point to maintain a valid network topology. To globally enable STP, use the bridge stp enable command from the CLI configuration mode. Then configure the other global STP parameters for the bridge. The path cost and priority for each bridge link can be set using the bridge-linkpath-costand bridge-linkport-prioritycommand from the Wireless Interface configuration mode. The path cost and priority can also be set for the Ethernet port from the Ethernet Interface configuration mode. To view the current STP settings, use the show bridge stp command.

Enterprise	AP(config)#bridge			stp enable	6-104
Enterprise	AP(config)#bridge			stp forwarding-delay 2500	6-105
Enterprise	AP(config)#bridge			stp hello-time 500	6-106
Enterprise	AP(config)#bridge			stp max-age 4000	6-107
Enterprise	AP(config)#bridge			stp priority 40000	6-108
Enterprise	AP(config)#interface wireless a
Enterprise	AP(if-wireless g)#bridge-link path-cost 2 40				6-109
Enterprise	AP(if-wireless g)#bridge-link port-priority 2 64				6-110
Enterprise	AP(if-wireless g)#exit
Enterprise	AP#show bridge stp				6-111
Bridge MAC		: 00:30:F1:F0:9A:9C
Status		: Disabled
priority		:	32768
desiginated-root		:	priority = 0, MAC = 00:00:00:00:00:00
root-path-cost		:	0
root-Port-no		:	0
Hold Time		:	0	Seconds
Hello Time		:	0	Seconds
Maximum Age		:	0	Seconds
Forward Delay		:	0	Seconds
bridge Hello Time		:	2	Seconds
bridge Maximum Age		:	20	Seconds
bridge Forward Delay		:	5	Seconds
time-since-top-change: 3168				Seconds
topology-change-count:			0
Enterprise	AP#

6-26