SMC Networks SMC2552W-G2-17 manual Snmp Commands Function Mode

7 Command Line Interface

SNMP Commands

Controls access to this access point from management stations using the Simple Network Management Protocol (SNMP), as well as the hosts that will receive trap messages.

Table 7-9. SNMP Commands

Command	Function	Mode	Page
snmp-server community	Sets up the community access string to permit access	GC	7-42
	to SNMP commands
snmp-server contact	Sets the system contact string	GC	7-42
snmp-server location	Sets the system location string	GC	7-43
snmp-server enable server	Enables SNMP service and traps	GC	7-43
snmp-server host	Specifies the recipient of an SNMP notification	GC	7-44
	operation
snmp-server trap	Enables specific SNMP notifications	GC	7-45
snmp-server engine id	Sets the engine ID for SNMP v3	GC	7-47
snmp-server user	Sets the name of the SNMP v3 user	GC	7-47
snmp-server targets	Configures SNMP v3 notification targets	GC	7-49
snmp-server filter	Configures SNMP v3 notification filters	GC	7-50
snmp-server	Assigns SNMP v3 notification filters to targets	GC	7-51
filter-assignments
show snmp groups	Displays the pre-defined SNMP v3 groups	Exec	7-51
show snmp users	Displays SNMP v3 user settings	Exec	7-52
show snmp	Displays the assignment of users to SNMP v3 groups	Exec	7-52
group-assignments
show snmp target	Displays the SNMP v3 notification targets	Exec	7-53
show snmp filter	Displays the SNMP v3 notification filters	Exec	7-53
show snmp	Displays the SNMP v3 notification filter assignments	Exec	7-54
filter-assignments
show snmp	Displays the status of SNMP communications	Exec	7-55

7-40