SMC Networks SMC2552W-G2-17 manual +8 TAIPEI, Beijing

Advanced Configuration 6

Note: The access point also allows you to disable SNTP and set the system clock manually.

Set Time Zone – SNTP uses Coordinated Universal Time (or UTC, formerly Greenwich Mean Time, or GMT) based on the time at the Earth’s prime meridian, zero degrees longitude. To display a time corresponding to your local time, you must indicate the number of hours your time zone is located before (east) or after (west) UTC.

Enable Daylight Saving – The access point provides a way to automatically adjust the system clock for Daylight Savings Time changes. To use this feature you must define the month and date to begin and to end the change from standard time.

During this period the system clock is set back by one hour.

CLI Commands for SNTP – To enable SNTP support on the access point, from the global configuration mode specify SNTP server IP addresses using the sntp-server ip command, then use the sntp-server enable command to enable the service. Use the sntp-server timezone command to set the time zone for your location, and the sntp-serverdaylight-savingcommand to set daylight savings. To view the current SNTP settings, use the show sntp command.

Enterprise AP(config)#sntp-server ip 1 10.1.0.19		7-34
Enterprise AP(config)#sntp-server enable		7-34
Enterprise AP(config)#sntp-server timezone +8		7-36
Enterprise AP(config)#sntp-server daylight-saving		7-36
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>:	31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>:	31
Enterprise AP(config)#exit
Enterprise AP#show sntp		7-37
SNTP Information
=========================================================
Service State	: Enabled
SNTP (server 1) IP	: 10.1.10.19
SNTP (server 2) IP	: 192.43.244.18
Current Time	: 19 : 35, Oct 10th, 2003
Time Zone	: +8 (TAIPEI, BEIJING)
Daylight Saving	: Enabled, from Mar, 31st to Oct, 31st

=========================================================

Enterprise AP#

6-35