Electronic Analogue Clock on some models only

Instructions for the User

3.2 Electronic Analogue Clock (on some models only)

LIST OF FUNCTIONS

MINUTE-MINDER BUTTON

END OF COOKING BUTTON

CLOCK TIME ADJUSTMENT AND RESET

VALUE DECREASE BUTTON

VALUE INCREASE BUTTON

3.2.1 Setting the time

When the oven is used for the first time, or after an interruption in the

electricity supply, the display flashes at regular intervals. Press the key for 1 / 2 seconds to stop the display flashing and start the procedure

for setting the current time. Press the value modification keys or to increase or decrease the setting by one minute for each pressure.

Press one of the two value modification keys until the current time appears. 6/7 seconds after the last key is pressed, the clock will start from the time set.

At the end of each programmed operation 8 beeps will sound 3/4 times at intervals of about 1 and a half minutes. This sequence can be stopped at any time by pressing any key.

Page 9

Image 9

Smeg CS19ID-6, CS19IDA-6 manual Electronic Analogue Clock on some models only, Instructions for the User, List Of Functions

Contents

Index Introduction 1. PRECAUTIONS FOR SAFETY AND USENEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF NEVER USE THE HOB AS A WORK-TOP THE NAMEPLATE MUST NEVER BE REMOVED 2. INSTALLING THE APPLIANCE Instructions for the Installer2.1 Electrical connection must never be removed F five-wire cable cable of 5 x 2.5 mm2 2.2 LevellingF four-wire cable cable of 4 x 4 mm2 Operation at 380-415V3N~ use a H05RR 3. DESCRIPTION OF CONTROLS Instructions for the User3.1 The front panel KEY TO SYMBOLS HOB CONTROL KNOB FUNCTION SELECTOR KNOB Heating accelerator Power Function 3.2 Electronic Analogue Clock on some models only 3.2.1 Setting the timeLIST OF FUNCTIONS 3.2.2 Minute-Minder 3.2.3 Programming 3.2.4 DEMO Function 4.1 Cooking zones 4. HOBOperating Powers 4.1.1 4.1.2 Types of pans 4.1.3 Pan present device 4.1.4 Residual heat4.1.5 Locking-out the hob Operation Triggertemperature 4.2 Holding Function 5.1 Precautions and General Advice 5. USING THE OVEN5.2 Oven light 5.3 Storage compartment 6. ACCESSORIES AVAILABLE 7.1 Conventional cooking 7. COOKING ADVICEThe oven door must be closed during cooking operations FUNCTION SELECTOR THERMOSTAT SET AT 50 - 250C 7.2 Hot air cooking 7.3 Grilling FUNCTION SELECTOR THERMOSTAT AT MAXIMUM SETTINGThe oven door must be closed while cooking is in progress FUNCTION SELECTOR THERMOSTAT FROM 50 C TO 250C 7.4 Hot air grilling FUNCTION SELECTOR THERMOSTAT SET ON 7.5 Defrosting It is normal for the thermostat light to switch on and off at regular 7.6 Rotisserie cookingWARNING the supports B must be fitted as shown on the right The oven door must be closed while cooking is in progress GRILLING CONVENTIONAL COOKING7.7 Recommended cooking tables PASTA SWEETS CONFECTIONERY HOT-AIR COOKING 8.1 Cleaning the ceramic hob 8. CLEANING AND MAINTENANCE8.2 Cleaning stainless steel 8.2.1 Routine daily cleaning 8.3.1 Self-cleaning liners 8.3 Cleaning the oven without self-cleaning liners8.3.2 Using the self-cleaning liners 8.3.3 Maintenance of self-cleaning liners 8.3.4 Removing the self-cleaning liners 8.4 Door glazing 9. EXTRAORDINARY MAINTENANCE 9.1 Changing the light bulbUse only light bulbs approved for ovens T 300C 9.3 Oven door gasket 9.2 Removing the door

Smeg CS19ID-6, CS19IDA-6 Electronic Analogue Clock on some models only, Instructions for the User

Models: CS19ID-6 CS19IDA-6

3.2 Electronic Analogue Clock (on some models only)

LIST OF FUNCTIONS

3.2.1 Setting the time