Remote control

The remote does not function.

•Point the remote at the remote sensor on the receiver.

•Remove any obstacles in the path between the remote and the receiver.

•Replace all the batteries in the remote with new ones, if they are weak.

•Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 37).

•Make sure you select the correct input on the remote.

•When you operate a programmed non- Sony component, the remote may not function properly depending on the model and the maker of the component.

Reference sections for clearing the memory

To clear

See

All memorized settings

page 36

 

 

Customized sound fields

page 64

 

 

Error messages

If there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

PROTECTOR

Irregular current is output to the speakers, or the upper panel of the receiver is covered with something. The receiver will automatically turn off after a few seconds. Check the connection of speakers and turn on the power again.

For other messages, refer to “Message list after Auto Calibration measurement” (page 49) and “DIGITAL MEDIA PORT message list” (page 86).

Information Additional

121GB