The TV’s remote commander cannot be used to control the connected component when using the Control for HDMI function.

•Change the input of the receiver to the HDMI input connected to the component.

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

Ground (earth) wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 74).

•Press DISPLAY so that the frequency appears on the display.

RDS does not work.*

•Make sure that you are tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.*

•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

*Models of area code CEL, CEK, ECE only.

120GB