To cancel the measurement

The measurement will be canceled when you do the following:

–Press ?/1, input buttons or MUTING.

–Press SPEAKERS (OFF/A/B/A+B) on the receiver.

–Change the volume level.

–Connect the headphones.

Confirming/saving the measurement results

1 Confirm the measurement result.

When the measurement ends, a beep sounds.

2 Press V/v to select the item you want, then press .

Item

Explanation

Retry

Performs the Auto

 

Calibration again.

 

 

Save

Saves the measurement

 

results and exits the setting

 

process.

 

 

Warning

Displays warning

 

concerning the

 

measurement results. See

 

“Message list after Auto

 

Calibration measurement”

 

(page 49).

 

 

Phase*

Displays the phase of each

 

speaker (in phase/out of

 

phase).

 

 

Distance

Displays the measurement

 

result for speaker distance.

 

 

Level

Displays the measurement

 

result for speaker level.

 

 

Exit

Exits the setting process

 

without saving the

 

measurement results.

 

 

*When the speaker(s) is (are) out of the phase, “OUT” is displayed on the TV screen. The “+” and “–” terminals of the speaker may be connected the other way around. However, depending on the speakers, “OUT” appears on the TV screen even though the speakers are connected properly. This is because of the speakers’ specifications. In this case, you can continue to use the receiver.

3 Select “Save” in step 2, then press to save the measurement result.

Started Getting

continued

47GB