6:Preparing the receiver and the remote
Connecting the AC power cord (mains lead)
Connect the supplied AC power cord (mains lead) to the AC INLET terminal on the receiver, then connect the AC power cord (mains lead) to a wall outlet.
Notes
•Before connecting the AC power cord (mains lead), make sure that metallic wires of the speaker cords are not touching each other between the SPEAKERS terminals.
•Connect the AC power cord (mains lead) firmly.
AC INLET terminal
To the wall outlet
AC power cord (mains lead) (supplied)
A several space is left between the plug and the rear panel even when the power cord (mains lead) is inserted firmly. The cord is supposed to be connected this way. This is not malfunction.
Performing initial setup operations
Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults.
Be sure to use the buttons on the receiver for this operation.
1,2 2,3 2,3
1
2 While holding down TONE MODE and 2CH/A.DIRECT, press POWER to turn on the receiver.
3 Release TONE MODE and 2CH/ A.DIRECT after a few seconds.
After “CLEARING” appears on the display for a while, “CLEARED !” appears.
All the settings you have changed or adjusted are reset to the initial settings.
36GB