The measurement process will take approximately 30 seconds. Wait until the measurement process completes.
To cancel Auto Calibration
The measurement will be canceled when you do the following:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the receiver.
– Change the volume level.
– Connect the headphones.
102GB
Measurement starts.
6
Measurement starts in 5 seconds. A count down is displayed.
Note
While the time is counting down, stand away from the measurement area to avoid measurement error.
to start
5 Press V/v repeatedly to select “A.CAL START”, then press the measurement.
.
Receiver operation is enabled.
3 Press MENU.
4 Press V/v repeatedly to select “<AUTO CAL>” , then press
Press AMP.
2
Performing Auto Calibration
To operate on the receiver
1 Press GUI MODE repeatedly to select “GUI OFF”.

Tips

•Operations other than turning the receiver on or off are deactivated during Auto Calibration.

•The measurements may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used.

To confirm/save Auto Calibration when GUI function is turned off

1Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display window.

Measurement

Display

Explanation

result

window

 

 

 

 

When the

COMPLETE

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

E-

See “Message

measurement

xxx:xx list after Auto

process fails

 

Calibration

 

 

measurement”

 

 

(page 49).

2Press V/v repeatedly to select the item, then press .

Item

Explanation

RETRY

Performs the Auto Calibration

 

again.

 

 

SAVE EXIT

Saves the measurement

 

results and exits the setting

 

process.

WARN CHECK Displays a warning concerning the measurement results. See “Message list after Auto Calibration measurement” (page 49).

PHASE INFO.

Displays the phase of each

 

speaker (in phase/out of

 

phase). See “When you select

 

“PHASE INFO.””.

 

 

DIST. INFO.

Displays the measurement

 

result for speaker distance.

 

 

LEVEL INFO.

Displays the measurement

 

result for speaker level.