Notes

•The Auto Calibration function does not work if

–SPEAKERS (OFF/A/B/A+B) is set to off.

–headphones are connected.

•If the muting function has been activated before you perform Auto Calibration, the muting function will be set to off automatically.

Optimizer microphone

1 Connect the supplied optimizer microphone to the AUTO CAL MIC jack.

2 Set up the optimizer microphone.

Place the optimizer microphone at your seating position. Use a stool or tripod so that the optimizer microphone remains at the same height as your ears.

On setting up the active subwoofer

•When a subwoofer is connected, turn on the subwoofer and turn up the volume beforehand. Turn the MASTER VOLUME knob to just before the mid-point.

•If you connect a subwoofer with the crossover frequency function, set the value to maximum.

•If you connect a subwoofer with an auto standby function, set subwoofer to off (deactivated).

Note

Depending on the characteristics of the subwoofer you are using, the setup distance value may be further away from the actual position.

Using the receiver as a pre- amplifier

You can use the Auto Calibration function when you use the receiver as a pre-amplifier. In this case, the distance value shown on the display may differ from the actual distance value. However, there will be no problems even if you continue to use the receiver with that value.

Started Getting

45GB