Test Tone menu parameters

xTest Tone

• OFF

• AUTO

The test tone is output from each speaker in sequence.

• FL, CNT, FR, SR, SBR, SBL, SB, SL, SW You can select which speakers will output the test tone.

xPhase Noise

•OFF

•FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, SR/SL, SR/SBR, SBR/SBL, SR/SB, SBL/ SL, SB/SL, SL/FL, FL/SR

Lets you output the test tone sequentially from adjacent speakers.

Some items may not be displayed, depending on the setting of the speaker pattern.

xPhase Audio

• OFF

• FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, SR/SL, SR/SBR, SBR/SBL, SR/SB, SBL/ SL, SB/SL, SL/FL, FL/SR

Lets you output front 2 channel source sound (instead of the test tone) sequentially from adjacent speakers.

Some items may not be displayed, depending on the setting of the speaker pattern.

Other parameters of Speaker settings menu

xBI-AMP Speaker

• ON

If you connect front speakers in a bi- amplifier configuration, select “ON”.

• OFF

If you have not connected surround back speakers, select “OFF”.

Note

Set “BI-AMP Speaker” to “OFF”, then connect the surround back speakers to this receiver when you want to change the connection from a bi-amplifier connection to a surround back speakers connection. Re-set up the speakers after you connect the surround back speakers. Refer to “Auto Calibration” (page 44) or “Manual Setup” (page 66).

xCrossover Freq

(Speaker crossover frequency)

Lets you set the bass crossover frequency of speakers that has been set to “SMALL” in the Speaker menu. Measured speaker crossover frequency is set for each speaker after the Auto Calibration.

The adjusted value is set for each speaker when you adjust the speaker crossover frequency using “Crossover Freq” after the Auto Calibration.

70GB