1 After checking the following items, hold the cassette with the tape window facing upward, then insert it into the recorder (this unit) as illustrated on page 23.
.
Item to check | See section |
|
|
Make sure that the REC/SAVE switch | |
of the cassette is set to REC. | |
|
|
Check for tape slack. | |
| |
|
|
Make sure that the “HUMID!” alarm is | |
not shown in the time counter display. |
|
|
|
The cassette is automatically drawn into the unit and the tape is wound round the head drum. The tape is stationary while the head drum rotates, and the STOP button lights.
If the REC INHIBIT indicator lights:
It indicates that the REC/SAVE switch of the loaded cassette has been set to SAVE. Press the EJECT button in the tape transport control section to remove the cassette, then set the REC/SAVE switch to REC and reload the cassette.
Note
When ejecting and loading cassettes, make sure that the unit has been powered on.
2 Hold down the REC button and press the PLAY button.
This puts the unit into recording mode, and the tape starts moving.
3 Press the PLAY button on the player.
The player starts the playback operation, at which point this unit starts recording the input playback signals.
Cautions
•Once you have started recording, you cannot change the audio mode selection.
•If on a tape there is a point where the audio mode is switched, it is not possible to carry out insert editing over a section including that point.
Playback and Recording 2 Chapter
Recording 29