Overview 1 Chapter

is used, the built-in 75 Ω termination switch turns off automatically.

The REF. VIDEO OUT connector outputs a reference video signal, except when i.LINK is selected in the INPUT SELECT section (see page 11).

eVIDEO OUT 1 and 2 (SUPER) connectors (BNC type)

These connectors output analog composite video signals. When the CHARA. DISPLAY menu item (see page 59) is set to ON (factory default setting), connector 2 (SUPER) outputs a signal with superimposed text information.

fS VIDEO OUT connector (4-pin)

This connector outputs an S-video signal with separated Y (luminance) and C (chroma: 3.58 MHz for DSR-1800 or 4.43 MHz for DSR-1800P) components.

gCOMPONENT VIDEO OUT Y/R− Y/B− Y connectors (BNC type)

These connectors output analog component video signals (Y/R− Y/B− Y).

hTIME CODE IN/OUT connectors (BNC type) Input SMPTE time code (for DSR-1800) or EBU time code (for DSR-1800P) externally generated to the IN connector.

The OUT connector outputs a time code according to the operating state of the unit, as follows:

During playback: the playback time code

During recording: the time code generated by the internal time code generator or the time code input to the TIME CODE IN connector. When the EE OUT PHASE menu item (see page 61) is set to MUTE, no time code is output.

BDigital signal input/output section (optional DSBK-1801/1802/1803 boards required)

 

DV IN/OUT

 

 

a

DV IN/OUT connector

SDTI(QSDI)

 

IN

OUT

 

 

b SDTI (QSDI) IN/OUT connectors

 

SDI

DIGITAL AUDIO(AES/EBU)

IN

OUT

IN CH-1/2 CH-3/4 OUT CH-1/2 CH-3/4

f DIGITAL AUDIO (AES/EBU) OUT connectors

eDIGITAL AUDIO (AES/EBU) IN connectors

dSDI OUT connectors

cSDI IN and active through output connectors

18 Location and Function of Parts