In addition to straightforward tape dubbing, you can also use this unit to dub automatically from the beginning of the tape to the end through the SDTI (QSDI) or i.LINK interface.
•To use the SDTI (QSDI) interface, the optional DSBK- 1802 board is required.
•To use the i.LINK interface, the optional
Use the following procedure.
| A | B |
|
|
| MARK |
|
1,9 | 2,4 | 3,4,5 | 7 |
1 Press the MENU button on the menu control panel.
3 Chapter
When a tape recorded on a
Notes
• Use a tape recorded in the DVCAM format. A tape |
recorded in DV format cannot be used as a source tape |
for dubbing through the SDTI (QSDI) or i.LINK |
interface. |
• Regardless of the audio recording mode setting of this |
unit, dubbing is performed with the original audio |
recording mode unchanged |
SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
Monitor screen
Setup menu
Time counter display
Operation Editing for Functions Convenient
or |
• Approximately the last 2 minutes of the tape may not be |
copied because of differences in tape lengths. (If an |
index picture is recorded in this portion, it may also not |
be copied.) |
• A continuous recorded section of approximately 5 |
seconds is required before the recording start point. It is |
recommended to record beforehand color bars or a |
similar signal at the start point of the source tape to be |
dubbed on this unit. |
Connections for dubbing via SDTI (QSDI) interface
To carry out dubbing through the SDTI (QSDI) interface, connect the REMOTE and SDTI (QSDI) IN/OUT connectors on this unit to those on the
For details of the connections and switch settings, see “Connections for SDTI (QSDI) Dubbing” on page 86.
Connections for dubbing via i.LINK interface To carry out dubbing through the i.LINK interface, connect the i.DV IN/OUT connectors on this unit and the player.
2 Press the J or j button to select “AUTO FUNCTION.”
SYSTEM MENU |
| Auto func |
SETUP MENU |
| |
AUTO FUNCTION |
| Time counter display |
HOURS METER |
| |
|
| |
|
|
|
Monitor screen
50 Digitally Dubbing Signals in DVCAM Format