Playback and Recording 2 Chapter

Repeat Playback—Automatic Cyclical Playback

Proceed as follows to perform automatic cyclical playback of recording (repeat playback) between selected start and end points.

1 Set the desired repeat start and end points with the REPEAT FUNCTION menu item (see page 56).

You can set points A and B as start and end points by following the procedure described in the next section.

2 Set the REPEAT MODE menu item (see page 56) to ON.

The REPEAT indicator lights.

3 Press the SET (YES) button to save the new setting and close the menu. 4 Press the PLAY button.

The unit repeats playback between the repeat start and end points set in step

1.

Setting Points A and B for Repeat Playback

You can set the repeat playback start point (point A) and end point (point B) by using the current tape position or inputting time code values.

To perform repeat playback after setting points A and B, press the PLAY button when the REMOTE button is off. When the DSRM-10 Remote Control Unit is connected to the CONTROL S connector on the front panel, you can also start repeat playback by pressing its PLAY button with the REMOTE button of this unit off.

Setting the current tape position as point A or B

Proceed as follows to set the current tape position as point A or B for repeat playback.

Buttons used for setting the current tape position as point A

A

B

MARK

Buttons used for setting the current tape position as point B

In the following explanation of how to set points A and B for repeat playback, these three buttons are referred to as the KAbutton, Bk button, and SET (YES) MARK button, respectively.

34 Playback