e HEADPHONES connector (stereo phone jack)

g AUDIO INPUT LEVEL control knobs

Connect stereo headphones for headphone monitoring

When recording, you can use these knobs to set audio input

during recording or playback.

levels for CH-1 (channel 1), CH-2, CH-3 and CH-4,

The audio signal you want to monitor can be selected with

respectively.

the MONITOR SELECT switches on the menu control

You can make these knobs inoperative with the REC

panel.

LEVEL menu item (see page 64).

f CONTROL S connector (stereo minijack)

 

Connect a SIRCS-compatible remote control unit such as

 

the DSRM-10.

 

AInput selection/audio mode display section

a INPUT display b VIDEO display

c AUDIO CH1 1/2 display d AUDIO CH2 3/4 display e REC MODE display f PB FS display

Overview 1 Chapter

aINPUT display

Indicates the input signal selected with the SDTI/i.LINK button in the INPUT SELECT section.

V:SDTI: Digital video signal in SDTI(QSDI) format

SDTI: Digital video and audio signals in SDTI(QSDI) format

i.LINK: Digital video and audio signals in i.LINK- compatible DV format

The SDTI/i.LINK button to function fully requires the optional DSBK-1802 and 1803 boards to be installed. The signal without the corresponding optional board installed in the unit can be neither selected nor indicated.

bVIDEO display

Indicates the input video signal selected with the VIDEO IN button in the INPUT SELECT section. COMPOSITE: Composite video signal

Y− R, B: Y, R− Y and B− Y component video signals

SVIDEO: S-video signal

SDI: SDI video signal (optional DSBK-1801 board required)

SG: Video test signal

cAUDIO CH1 1/2 display

Indicates the input audio signal selected with the CH-1,1/2 button in the INPUT SELECT section.

ANALOG: Analog audio signal

AES/EBU: Digital audio signal in AES/EBU format (optional DSBK-1801 board required)

SDI: SDI audio signal (optional DSBK-1801 board required)

SG: Audio test signal

dAUDIO CH2 3/4 display

Indicates the input audio signal selected with the CH-2,3/4 button in the INPUT SELECT section. The indications available are the same as for the AUDIO CH1 1/2 display described above.

eREC MODE (audio recording mode) display Indicates the audio recording mode (2CH or 4CH) selected with the REC MODE menu item (see page 63).

fPB FS (playback audio sampling frequency) display

Indicates the sampling frequency (48 kHz, 44.1 kHz or 32 kHz) at which audio is recorded on tape.

Location and Function of Parts

9