To display the desired time data in the time counter display
Time data type indicators
Time counter display
|
|
|
| INPUT | V:SDTI |
| SDTI | i.LINK |
|
|
|
|
| VIDEO | COMPOSITE | SDI | SG | ||
|
|
|
| CH11/2 | ANALOG | AES/EBU | SDI | SG | |
|
|
|
| AUDIO | ANALOG | AES/EBU | SDI | SG | |
|
|
|
| CH23/4 | |||||
1 | 2 | 3 | 4 | PB FS | 48k44.1k32k | REC MODE | 2CH4CH |
COUNTER SEL button
A B
MARK
Open the door on the lower part of the front panel, and press the COUNTER SEL button.
Each press of this button cycles through three options: CNT value, time code, and user bit data. The time data type indicator for each option lights as it is selected.
Time data | Time data shown in the time counter |
type | display |
indicator |
|
|
|
COUNTER | CNT (count value of the time counter) |
|
|
TC | Time code (when recording, the time code is |
| generated by the internal time code |
| generator; when playing back, the time code |
| is read from the tape.) |
|
|
User bit data (when recording, the user bit | |
| data is according to the most recent settings; |
| when playing back, the user bit data is read |
| from the tape.) |
|
|
Note
When the REMOTE button on the front panel is lit, the COUNTER SEL button does not operate while the tape is moving. In such cases, use the external equipment connected to the REMOTE connector on the rear panel to select the time data.
To reset the CNT value
Press the RESET (NO) button on the menu control panel. This resets the CNT value to 0:00:00:00.
Note
During playback, if the recording on the tape includes discontinuities, the counter may operate incorrectly at the corresponding points.
Using the Internal Time Code
Generator
You can set the initial time code value before recording the time code generated by the internal time code generator onto a tape. In addition, you can use the user bits to record such data as the date, time, scene number, reel number, or other useful information.
When an external time code generator is connected to the TIME CODE IN connector, the internal time code generator can be locked to (synchronized with) an external time code.
bit data |
|
| 3Chapter |
To set the initial time code value and user | |||
|
|
| Convenient |
|
|
| forFunctions |
|
|
| 1 |
| A | B | Editing |
|
| MARK | Operation |
|
|
| |
2 | 3 | 4,5,6 | 7 |
1 Press the COUNTER SEL button to light the time data type indicator “TC” or
TC: To set the initial time code value.
The current time code value or user bit data is shown in the time counter display.
Setting the Time Data 43