Sony DSR-200 Charging and installing the battery pack, Charging the battery pack, Charging time

Charging and installing the battery pack

Before using your digital camcorder, you first need to charge and install the battery pack (not supplied). To charge the battery pack, use the AC-V615 AC power adaptor (not supplied).

This digital camcorder does not interface with “InfoLITHIUM” batteries. The remaining time (minutes) indication does not appear when using “InfoLITHIUM” batteries.

Charging the battery pack

Charge the battery pack on a flat surface without vibration. (1) Connect the power cord to the AC power adaptor.

(2) Align the surface of the battery pack indicated by the zmark with the edge of the terminal shutter of the AC power adaptor. Then fit and slide the battery pack in the direction of the arrow.

(3) Connect the AC power cord to a wall outlet. The CHARGE lamp (orange) lights up. Charging begins.

When the CHARGE lamp goes out, normal charge is completed. For full charge, which allows you to use the battery longer than usual, leave the battery pack in place for approximately one hour. Unplug the unit from the wall outlet, then remove the battery pack and install it into the digital camcorder. You can also use the battery pack before it is completely charged.

Getting started

1 2

Charging time

Battery pack	Charging time* (min.)
NP-F930	330 (270)
NP-F730/720	250 (190)

3

CHARGE

The time required for a normal charge is indicated in parentheses.

*Approximate minutes to charge an empty battery pack using the AC-V615 AC power adaptor. (Lower temperatures require a longer charging time.)

21

DSR-200 U/C 3-858-622-22(1). E