Location and Function of Parts

Front View

0Switch guard fitting screws How to fit the switch guard

1.Detach the two screws (M3).

2.Place the supplied switch guard so that the EZ MODE button, A.IRIS MODE switch and ATW button are covered, and retain it using the two screws detached in step 1.

Switch guard (supplied)

1MIC IN +48 V connector

2VF connector

3FILTER control

4Lens mount

5SHUTTER switch

6TAKE button

7AUDIO LEVEL knob

8WHT/BLK switch

9VTR button

Overview 1 Chapter

1MIC (microphone) IN +48 V connector (XLR 3- pin, female)

Connect the supplied microphone or an optional microphone (operable with a 48 V supply).

2VF (viewfinder) connector (20-pin)

This is the connector for the DXF-701WS/701WSCE viewfinder.

3FILTER control

Select the color temperature conversion filter appropriate to the lighting conditions. (See page 47.)

4Lens mount

Attach the zoom lens here.

5SHUTTER switch

Use this switch to set the shutter speed, CLS (clear scan), or EVS setting (see page 104). Usually, set this switch to OFF.

6TAKE button

Press this button to specify an editing point (Mark IN/ OUT or Cue point) at the current tape position during shooting. (See page 67.)

7AUDIO LEVEL knob

You can use this knob to manually adjust the channel 1 audio recording level.

8WHT/BLK (white/black) switch

This switch is used for automatic adjustment of the white balance and black balance. (See pages 100 to 103.)

9VTR button

Pressing this button starts and stops recording on the VCR.

0Switch guard fitting screws

If you will not use the EZ MODE button (4 on page 13), A.IRIS MODE switch (6 on page 13) and ATW button (!¢ on page 13), fit the supplied switch guard to avoid miss-operation of them.

Chapter 1 Overview 11