Overview 1 Chapter
Location and Function of Parts
Note |
| selected on the camera or camcorder. However, it |
You can switch the scan size of the | operates in 4:3 mode when used on the | |
701WSCE in accordance with the aspect ratio | 300P. |
1 BATT indicator
TALLY
TAKE REC BATT
2 TAKE/TALLY indicator
3 REC/TALLY indicators
4 SHUTTER indicator
SHUTTER | GAIN UP |
5GAIN UP indicator
6Eyepiece focusing knob
7Accessory fixing screw hole
8Tally lamp
Microphone holding screw
Eye cup
Microphone holder
Microphonea)
9 Eyepiece release catch
0 BRIGHT control !¡ CONTRAST control
!™ PEAKING control
!£ TALLY switch
!¢ Viewfinder connector
a) Not supplied with the optional
This indicates when the battery capacity is low.
2TAKE/TALLY indicator (orange)When using the ClipLink function while shooting, this indicator lights when the TAKE button (6 on page
11)has been pressed to set a Mark IN point and goes out when a Mark OUT point is set.
• From the time when you press the VTR button (9 on page 11 and ! on page 27) on the lens or camcorder, this flashes until recording starts, then stays on continuously during recording.
• This is also used to indicate a fault. (See page 115.)
• The lower indicator can be disabled by menu setting. (See page 86.)
28 Chapter 1 Overview