9LENS connector (12-pin)

If you use a lens with cable, connect the lens cable.

0VIDEO OUT connector (BNC)

This outputs the video signal captured by the camcorder.

!¡ REMOTE connector 2 (10-pin)

Connect the optional RM-M7G Remote Control Unit to this connector. Set the CAMERA HEAD SELECT switch on the bottom of RM-M7G to 1.

You can also connect a remote control unit with microphone.

Note

EZ mode cannot be used if the RM-M7G is connected to the camcorder.

For more information about a remote control unit with microphone, contact your Sony dealer.

Overview 1 Chapter

Rear section

1 Cassette holder

2 GEN LOCK IN connector

3 TC IN connector

4 TC OUT connector

5 S VIDEO OUT connector

6 MONITOR OUT connector

7 AUDIO OUT CH-1/CH-2 connectors

1Cassette holder

Power the camcorder and press the EJECT button to open the lid. Insert the cassette and close the lid by pressing the indication “PUSH” .

2GEN LOCK IN (gen lock video input) connector (BNC)

When synchronizing the camcorder to an external signal, input a reference video signal (VBS or BS).

3TC IN (time code input) connector (BNC) Input an external signal for synchronizing the built-in time code generator. Use an SMPTE (DSR-300) or EBU (DSR-300P) time code signal.

Note

Use a jitterless LTC signal. Using an LTC signal reproduced by other equipment may cause the camcorder to malfunction.

Chapter 1 Overview 23