Sony KZ 42TS1 Connecting a VCR and Cable, When connecting both Video OUT and S Video OUT, Tip

Connect the cable TV cable to the VCR’s IN jack.

Installing and Connecting the TV

Connecting a VCR and Cable

Use this hookup if:

• You have cable TV that does not require a cable box.

Disconnect all power sources before making any connections.

1

2 Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack to the TV’s VHF/UHF jack.

3 Using AUDIO and S VIDEO cables, connect the VCR’s Audio and S Video OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.

Rear of TV

AUDIO-R (red) AUDIO-L (white)

VIDEO (yellow)

							VHF/UHF
VIDEO IN 1	COMPONENT VIDEO IN 1				AUDIO OUT
R AUDIO L VIDEO S VIDEO	R AUDIO L	Y	PB	PR	R	L	AC IN
						CONTROL	IN
						S
	R AUDIO L	Y/G	PB/B	PR/R	HD	VD
							OUT
VIDEO IN 2	COMPONENT VIDEO IN 2 / RGB IN					SUB
						WOOFER
	S VIDEO						VCR

VMC-810S/820S (not supplied)

YC-15V/30V (not supplied)

75-ohm coaxial cable (supplied)

Cable

Tip

If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S

VIDEO cable.

When connecting both VIDEO OUT and S VIDEO OUT

You can select which jack the TV receives the input signal from on the menu screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2) separately. The TV is factory set to receive S video input signals.

1Press VIDEO repeatedly until the desired video input appears.

2Press MENU.

3Press V/v to select(Custom Setup), then press .

4Press V/v to select “Auto YC,” then press .

5To watch the pictures input from the S VIDEO input jack:

Press V/v to select “On,” then press .

To watch the picture input from the VIDEO input jack:

Press V/v to select “Off,” then press .

6Press MENU to exit the menu screen.

8 (US)