10 (US)
Installing and Connecting the TV
HD VD
IN
OUT
PB/BY/G PR/R
LR
AUDIO
LR
VHF/UHF
AC IN
AUDIO OUT
COMPONENT VIDEO IN 2
/
RGB IN SUB
WOOFER
CONTROL
S
VIDEO
LR
AUDIO
PBYPR
LR
AUDIO
S VIDEO
VIDEO IN 1 COMPONENT VIDEO IN 1
VIDEO IN 2
YC-15V/30V (not supplied)
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
VMC-810S/820S
(not supplied)
VCR
Satellite
antenna
cable
S VIDEO
Rear of TV Satellite receiver
75-ohm
coaxial cable
(supplied)
Cable
YC-15V/30V
(not supplied)
VMC-
810S/820S
(not supplied)
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
1Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2Connect the CATV cable to the VCR’s VHF/UHF IN jack.
3Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
4Using AUDIO and S VIDEO cables, connect the satellite receiver’s
AUDIO and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO
IN jacks.
5Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Tips
•Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for
instructions.
•Use VIDEO on the remote to select VIDEO IN 1 to watch satellite TV or the VCR (your
VCR must be turned on). Use 0-9 and ENTER or CH +/– on the remote to watch cable TV.
•If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.