Runco CW-42i manual Enabling/disabling remote control wireless transmission, Loop Out Setting

OSD (On Screen Display) Controls

Enabling/disabling remote control wireless transmission

This function enables/disables remote control wireless transmission.

Example: Setting “OFF” Perform the following operations.

Press the MENU button on the remote control to display the MAIN MENU on the screen, then...

1.	Use the	and	buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen
appears.
				INSTALL 3				3 / 3
2.	Use the	and	buttons to select “IR ENABLE”.	PREVIOUS PG		:	LAST
				INPUT SELECT
				TIMER
				CONTROL LOCK :			OFF
3.	To set the IR ENABLE to “OFF”...			IR ENABLE		:	ON
				LOOP OUT		:	OFF
Use the and buttons to select “OFF”, then press the MENU button.				ID NUMBER		:	ALL
The mode switches as follows each time the or button is pressed: OFF ON				VIDEO WALL
				SEL.	ADJ.		EXIT RETURN

4.Once the setting is completed ...

Press the EXIT button to return to the main menu.

To delete the main menu, press the EXIT button once more.

Loop Out Setting

Information

■ IR ENABLE settings

ON ........ Enables remote control wireless transmission.

OFF ....... Disables remote control wireless transmission.

Set “OFF” to avoid unwanted control from other remote controls.

■ Restoring the factory default settings

Select “FACTORY” under the INSTALL 1 menu.

Note that this also restores other settings to the factory defaults.

When this feature is set to ON, the received signal will be looped out. Example: Setting “ON”

Perform the following operations. Press the MENU button on the remote control to display the MAIN MENU on

the screen, then...

1. Use the	and	buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen
appears.
					INSTALL 3				3 / 3
					PREVIOUS PG
2. Use the	and	buttons to select “LOOP OUT”.			TIMER
					INPUT SELECT		:	LAST
					CONTROL LOCK :			OFF
3. To set the LOOP OUT to “ON”... Use the			and	buttons to select “ON”.	IR ENABLE		:	ON
					LOOP OUT		:	OFF
					ID NUMBER		:	ALL
The mode switches as follows each time the			or	button is pressed: OFF ON	VIDEO WALL
					SEL.	ADJ.		EXIT RETURN
Information
■ LOOP OUT settings
ON ........ The received signal will be looped out via PC1 terminal or VIDEO1 terminal.
OFF ....... The received signal will not loop out.
* Even if LOOP OUT is ON, signals would not be sent out if POWER is being turned off.

■ To connect to another display, refer to Loop Out Setting

■ If the RGB/PC1 signal is present at the time the power is switched on...

The RGB/PC1 input will be displayed regardless of the setting of LOOP OUT.

■ Restoring the factory default settings

Select “FACTORY” under the INSTALL 1 menu. Note that this also restores other settings to the factory defaults. 50