Runco CW-42i manual ID Number Setting, To set the ID Number to O2, All

OSD (On Screen Display) Controls

ID Number Setting

When using more than one of these displays, this function sets ID numbers so that operation of the remote control does not cause multiple monitors to operate at the same time.

Example: Setting “2”

Perform the following operations.

Press the MENU button on the remote control to display the MAIN MENU on the screen, then...

1.Use the and buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen appears.

2.Use the and buttons to select “ID NUMBER”.

3.To set the ID NUMBER to “O2”...

Use the and buttons to select “2”.

The mode switches as follows each time the and

ALL	1		2	....		255	256
			INSTALL 3			3 / 3
		PREVIOUS PG
		TIMER
		INPUT SELECT		:	LAST
		CONTROL LOCK :			OFF
		IR ENABLE		:	ON
		LOOP OUT		:	OFF
		ID NUMBER		:	ALL
		VIDEO WALL
		SEL.	ADJ.		EXIT RETURN

* To reset back to ALL, press the CLEAR button.

button is pressed:

Information
■ ID NUMBER settings
ALL	ID NUMBER will not be set.
1 to 256	ID NUMBER will be set.

■ When the ID NUMBER has been set

You can also set ID NUMBER for each remote control to operate the plasma display individually. To do so, requires special remote control available only from Runco factory Service Department.

■ Restoring the factory default settings

Select “FACTORY” under the INSTALL 1 menu.

Note that this also restores other settings to the factory defaults.

To set the ID number for the remote control

(requires special remote control available only from Runco factory Service Department) Example: Setting “2”

1.Use the and buttons to select “ID NUMBER”.

2.To set the ID NUMBER to “2” ...

Use the	and	buttons to select “2”. The mode switches as follows each time the and button is pressed:
ALL 1	2	.... 255 256
	SELECT ID
	POSITION1: 1

ID NUMBER

: ALL

ADJ. EXIT RETURN

* To reset back to ALL, press the CLEAR button.

4. Once the setting is completed... Press the EXIT button to delete the SELECT ID screen.

51