Runco CW-42i Lum Set Link, Perform Steps 1-2 of VIDEO WALL, then, OSD On Screen Display Controls

OSD (On Screen Display) Controls

LUM SET LINK

Use this function to set a uniform brightness for each display.

Turn on the AUTO ID before the following operations.

Example: Setting “ON”

Perform Steps 1-2 of VIDEO WALL, then...

3.Use the and buttons to select “LUM SET LINK”.

4.Use the and buttons to select “ON”, then press the MENU button.

The mode switches as follows each time the or button is pressed: OFF						ON
		VIDEO WALL
		DIVIDER		:	OFF
		POSITION
		DISP. MODE		:	SPLIT
		AUTO ID
		IMAGE OPT
		P. ON DELAY		:	OFF
		LUM SET LINK		:	OFF
		REPEAT TIME		:	OFF
		SEL.	ADJ.		EXIT RETURN
	Information
	■ LUM SET LINK settings
	ON ...... Sets a uniform brightness for each screen in a 2x2 video wall.
	OFF .... Sets the individual screen brightness for each screen in a 2x2 video wall.

*Set “OFF” in a 3x3 video wall.

*When this function is set “ON”, connect your plasma displays with the remote cable (optional) in the order of the position numbers for the 2x2 video wall. See the drawing below.

*If there are changes in the DIVIDER or POSITION, the LUM SET LINK will automatically turn OFF.

REMOTE IN

REMOTE

OUT

		REMOTE
No. 1	No. 2	OUT
No. 4	No. 3		REMOTE
				IN
Display 1
			REMOTE
No. 1	No. 2		OUT
No. 4	No. 3	REMOTE
		IN
Display 4

No. 1	No. 2	REMOTE
No. 4	No. 3	OUT
Display 2
No. 1	No. 2	REMOTE
No. 4	No. 3	IN

Display 3

NOTE:

The remote control can not be operated unless the IR ENABLE is set to “OFF”.

56