Runco CW-42i Video Wall Setting, Perform the following operations, Once the setting is completed

OSD (On Screen Display) Controls

Video Wall Setting

Use this feature to configure a 2×2 or 3×3 video wall.

Perform the following operations.

Press the MENU button on the remote control to display the MAIN MENU on the screen, then...

1.Use the and buttons to select “INSTALL 3”, then press the MENU button. The “INSTALL 3” screen appears.

2.Use the and buttons to select “VIDEO WALL”, then press the MENU button. The “VIDEO WALL” screen

appears.		VIDEO WALL
	DIVIDER			:	OFF
	POSITION
	DISP. MODE			:	SPLIT
	AUTO ID
	IMAGE OPT
	P. ON DELAY			:	OFF
	LUM SET LINK			:	OFF
	REPEAT TIME			:	OFF
	SEL.		ADJ.		EXIT RETURN

3.Set the VIDEO WALL using and buttons. See page 53 to set DIVIDER.

See page 53 to set POSITION. See page 54 to set DISP. MODE. See page 54 to set AUTO ID.

See page 55 to set IMAGE ADJUST. See page 55 to set P. ON DELAY. See page 56 to set LUM SET LINK. See page 57 to set REPEAT TIME.

4.Once the setting is completed...

Press the EXIT button to return to the INSTALL 3 menu.

5.Press the EXIT button to return to the main menu. To delete the main menu, press the EXIT button once more.

NOTE:

A contingency method of shutting off the electric power should be used in cases of emergency during video wall setup.

Information

■ Restoring the factory default settings

Select “FACTORY” under the INSTALL 1 menu.

Note that this also restores other settings to the factory defaults.

52