MD an on Recording

Recording an MD

6Adjust the recording level.

•When recording a program source connected to the LINE (ANALOG) IN jacks.

1 Play the loudest section of the program source

you want to record (the part with the highest playback level).

2Turn REC VOL so that the peak level meters in the display just reach (but do not exceed) 0 dB.

•When recording a program source connected to a DIGITAL jack.

Adjustment is not necessary (proceed to step 7).

7Press REC PAUSE or PLAY/PAUSE to start recording.

8Start playing the program source.

To stop recording

Press STOP.

Do not turn off the power immediately after recording

This may prevent proper recording. If you do, recorded material may not be saved to the MD. When you eject the disc or press ENTER/YES, “TOC Writing” blinks in the display. Wait until “TOC Writing” has finished blinking before pressing Uor unplugging the AC power cord from the wall outlet.

To

Do this

Pause the recording

Press PLAY/PAUSE or REC PAUSE.

 

To resume recording, press PLAY/

 

PAUSE or REC PAUSE again.

 

 

Eject the MD

Press §EJECT. The MD cannot be

 

ejected during recording.

*The song number changes if you pause during recording. For example, if you pause while recording song 4, the portion recorded after the pause is recorded as song 5.

To protect an MD against accidental erasure

To make it impossible to record on an MD, slide the tab in the direction of arrow, opening the slot. To allow recording, close the slot.

Record-protect tab

Back of disc

Open

Marking Track Numbers While Recording

You can mark track numbers either manually or automatically. By marking track numbers at specific points, you can quickly locate the points later using the AMS knob, and perform a variety of edit functions.

EDIT/NO

AMS

r REC

Manual track marking

You can mark a track number manually any time during recording.

During recording, press rREC at the point where you want to mark a track number.

Automatic track marking

The unit marks track numbers differently depending on the source being recorded and the type of connections being used.

•When recording from CDs or MDs with this unit’s INPUT set to DIGITAL:

Track numbers are marked automatically. However, this function may not work properly with some multi disc (and one disc) CD players.

•In all other cases:

When “L.Sync” in the Setup Menu is set to “L.Sync On”, if the input level drops below a certain level for 1.5 seconds, the unit marks a new track number the next time it rises back above that level.

When “L.Sync” in the Setup Menu is set to “L.Sync Off” the unit marks a track number when the recording is started, but no track numbers are marked during recording.

24GB