Required cords

• Audio cords (not supplied) (2)

whitewhite

Left (L) Left (L)

Right (R)

Right (R)

redred

•Digital optical cable (not supplied) (1)

•Coaxial digital cable (not supplied) (1)

Making Connections

This section describes how to connect this unit to a mixer, amplifier, and other components (like a CD player).

Be sure to turn off the power of all components before making any connections.

pConnecting a mixer or amplifier

Connect the mixer or amplifier to the LINE (ANALOG) IN /OUT jacks using audio cables (not supplied). Connect the red plugs to the red (R) jacks and connect the white plugs to the white (L) jacks. Be sure to make all connections firmly to prevent hum and noise.

This unit

Mixer or Amplifier (etc.)

LINE

TAPE / MD

(ANALOG)

OUT IN

IN OUT

 

L

L

 

R

R

 

Signal flow

pConnecting digital components

(CD player, DAT deck, another MD deck, or an amplifier with digital input jacks)

If you make connections to a CD player, MD deck, or DAT deck (etc.) you can make digital recordings.

Connect using a digital optical cable (not supplied), or a digital coaxial cable (not supplied).

•Using a digital optical cable

Remove the protective caps from the optical jacks, then insert the plugs parallel to the jacks until they click into place. Do not fold or tie digital optical cables.

This unit

Digital component

DIGITAL

 

DIGITAL

 

COAXIAL OPTICAL

 

OPTICAL

 

 

 

IN

IN

 

IN OUT

 

 

 

Signal flow

•Using coaxial digital cables

This unit

Digital component

DIGITAL

 

DIGITAL

 

COAXIAL OPTICAL

 

COAXIAL

 

 

 

IN

IN

 

IN OUT

 

 

 

Signal flow

zIf “Din Unlock” and “C71” appear in the display

Check the digital optical cable or digital coaxial cable connections. Also make sure the power of the connected component is turned on.

zAutomatic conversion of digital sampling rates

A built-in sampling rate converter automatically converts digital signals with 32 kHz or 48 kHz sampling rates to the MD sampling rate (44.1 kHz).

This allows you to make digital recordings from DAT (32 kHz and 48 kHz) and satellite broadcasts (32 kHz and 48 kHz) in addition to CD and MD program sources.

Note

If “Din Unlock”, “C71” or “Cannot Copy” appears in the display, digital recording is not possible. In such cases, connect the program source to the LINE (ANALOG) IN jacks, set INPUT to ANLG, and make an analog recording.

pAfter completing all other connections, use the AC power cord to connect this unit to a wall outlet.

Started Getting

5GB