zAMS can also be used to skip directly to cue points 1 Press EDIT/NO twice to display “Setup Menu”.

2 Turn AMS to display “JOG:”, then push AMS.

3 Turn AMS to display “JOG : Cue”, then push AMS.

4 Press EDIT/NO to exit the Setup Menu.

Now, in addition to skipping to the beginning of each track, turning AMS will also skip to any cue points you may have specified.

To set AMS to skip only to the beginning of each track, select “JOG : Track” in step 3.

Note

If you press a pad to start playback, the cue point for the respective track cannot be recalled by pressing CUE. In such cases, use AMS to skip to the cue point (as described above).

zCue points can be assigned to pads

See “Assigning Cue Points to Pads” on page 13.

Adjusting the cue point

1Press CUE to recall the cue point.

2Hold down CUE and turn the scrub dial to adjust the cue point.

The unit repeats a 3 second section starting from the point playback was paused. The beginning of the 3 second section moves in sync with the motion of the scrub dial.

z For more precise adjustment of the cue point

Turn the scrub dial without holding down CUE.

The CUE indicator goes out and the sound is played back in sync with the motion of the scrub dial. (Sound may not be produced immediately when turning the dial backwards.)

3Press PLAY/PAUSE to start playback from the cue point.

Assigning Cue Points to Pads

This function allows you to assign up to 8 cue points to pads. Once you assign a cue point to a pad, you can skip to it simply by pressing the respective pad.

EDIT/NO

AMS

Pads

CUE

1Recall the cue point you want to assign to a pad.

For details, see “Recalling the cue point” on page 12.

2Hold down CUE and press the pad corresponding to the track number containing the cue point.

For example : If you recalled the cue point for track 3 in step 1, hold down CUE and press pad 3 (BANK 1). “Memorizing” appears momentarily and the indicator above the pad lights red to indicate that the cue point has been assigned.

Erasing a cue point from a pad

1Hold down STOP and press the pad containing the cue point you want to erase.

“Pad Erase?” and “–Rehearsal–” alternate in the display, and the unit repeats a 3 second section starting from the cue point to be erased.

If you decide not to erase the cue point

Press EDIT/NO or STOP.

2Press ENTER/YES or press the same pad again.

“Complete!!” appears in the display, and the pad indicator lights green.

(continued)

Functions Performance DJ

13GB