Sony MDS-DRE1 12GB, Selecting a Track, To stop playback automatically at the end, of each track, Recalling the cue point

Functions Performance DJ

Selecting a Track

To listen to tracks 9 through 32

Press BANK to switch to a different group (BANK) of tracks before pressing a pad.

The current BANK number is shown in the display.

Each BANK assigns another group of 8 tracks to the pads: BANK 1 n Tracks 1~8

(Track 1 = Pad 1, Track 2 = Pad 2, etc.)

BANK 2 n Tracks 9~16

(Track 9 = Pad 1, Track 10 = Pad 2, etc.)

BANK 3 n Tracks 17~24

(Track 17 = Pad 1, Track 18 = Pad 2, etc.)

BANK 4 n Tracks 25~32

(Track 25 = Pad 1, Track 26 = Pad 2, etc.)

zYou can also start playback by pressing PLAY/PAUSE after inserting the MD

In this case, playback starts from track 1. To play other tracks, turn AMS.

To	Do the following:
Stop playback	Press STOP.

Pause playback	Press PLAY/PAUSE. Press again
	to start playback again from the
	point at which it was paused.

Skip to next track	Turn AMS to the right.*

Skip back to beginning of	Turn AMS to the left.*
current or previous track

Eject the MD	Stop playback, then press

§EJECT on the front panel.

*In addition to skipping to the beginning of a track, you can also set AMS to skip to any cue points you may have specified.

Use the Setup Menu to specify the AMS (JOG) mode. For details, see “Specifying Cue Points” below.

To stop playback automatically at the end

of each track

Press SINGLE PLAY to light the “1” indicator.

Playback stops automatically at the end of each track. To cancel the single play mode, and have playback continue to the next track, press SINGLE PLAY again so that the “1” indicator goes out.

Specifying Cue Points

A cue point is a temporary “index” you can use to locate a specific point in a track. You can specify one cue point for each track.

EDIT/NO

AMS

0/)

CUE

PLAY/PAUSE

Scrub dial

1Start playing the track containing the desired point.

To move quickly toward the desired point

Hold down 0(fast reverse) or )(fast forward) .

2Press PLAY/PAUSE to pause at the desired point.

The PLAY/PAUSE indicator blinks.

To check the point

Hold down CUE.

The unit repeats a 3 second section starting from the point playback was paused.

To adjust the point

•Hold down CUE and turn the scrub dial.

The beginning of the 3 second section moves in sync with the motion of the scrub dial.

•Turn the scrub dial (without holding down CUE).

The sound plays in sync with the motion of the scrub dial. (Sound may not be produced immediately when turning the dial backwards.)

3Press PLAY/PAUSE again to resume playback.

The PLAY/PAUSE indicator lights and the unit stores the point specified in step 2 as a cue point.

Recalling the cue point

1Press CUE recall the cue point.

CUE lights up, PLAY/PAUSE blinks, and the unit immediately skips to and pauses at the previously specified cue point.