MD Recorded a Editing

Dividing a Track (Divide)

After recording, you can divide a track in two by marking a new track number at any point you want to access. This is especially useful when you record from an analog source (etc.) and several songs are recorded as a single track number, or when you want access to a certain point in the middle of a track. When you divide a track, the total number of tracks on the MD increases by one and all tracks following the divided track are renumbered automatically.

Example: Dividing track 2 to create individual track numbers for B and C.
Track

1

2

 

 

 

3

 

numbers

 

 

 

 

 

A

 

B

 

C

D

DIVIDE

 

 

 

 

 

 

 

 

 

 

 

Divide B and C

 

 

 

 

 

 

1

2

3

 

4

 

 

A

 

B

C

D

 

 

 

 

 

 

 

 

 

EDIT/NO

AMS

0/)

STOP

1During stop, play, or pause mode, press EDIT/NO to display the Edit Menu.2Turn AMS to display “Divide ?”, then press AMS.3Turn AMS to display the track number of the track you want to divide.

The REHEARSAL indicator lights up and the selected track starts to play.

4Listen to the track and press AMS at the point where you want to divide the track.

“–Rehearsal–” is displayed and playback starts repeating from the point where the track will be divided (rehearsal playback).

5Turn AMS while listening to the rehearsal to adjust the position of the divide point.

After an adjustment, the rehearsal resumes from the new position.

You can use AMS to adjust in minutes, seconds, or frames by pressing 0or )to switch between the different units. When adjusting by frames, “F” blinks next to the frame numbers. When adjusting by seconds, “S” blinks next to the seconds. When adjusting by minutes, “M” blink next to the minutes.

6Press AMS when the position is correct.

“Complete!!” appears for a few seconds and the track is divided. Playback begins from the beginning of the newly created track. The new track will not have a track name, even if the original track was named.

To cancel without dividing the track

Press EDIT/NO or STOP.

zYou can undo the divide

Use the undo function immediately after dividing the track (see page 35).

zYou can divide tracks while recording

Use the track marking function (see page 24).

zYou can adjust the length and interval of rehearsal playback

The following operations use the Setup Menu.

1 During stop, record, or record-pause mode, press EDIT/NO twice to display the Setup Menu.

2 Turn AMS to select one of the following parameters, then press AMS.

To change the rehearsal playback length : RH (L)*

To change the rehearsal playback interval : RH (I)

3Turn AMS (* or scrub dial) to set the value you desire, then press AMS.

4Press EDIT/NO to exit the Setup Menu.

The settings are retained even if the power is turned off.

The adjustable range of each parameter is as follows. The numbers in parenthesis are the default values.

RH (L): 0s00f to 9s85f in 1f steps (2s00f)

RH (I) : 0s to 8s in 0.5s steps (1.0s)

To cancel without completing the settings, press EDIT/NO. This returns the unit to the factory settings.

Note

If “Impossible” is displayed, the track cannot be divided.

This may occur if one of the tracks has been edited many times. This is due to a technical limitation of the MD system, it is not a mechanical error.

28GB