The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound | •Cancel the ATT function. |
| •Set the fader control to the center position for a |
| system. |
| •Rotate the volume control dial clockwise to adjust the |
| volume. |
| •Be sure to check that the digital connections are correct. Use |
| the supplied attachment to secure the adaptor. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected. •The reset button has been pressed.
tStore again into the memory.
Indications do not appear on the display.
•The clock display disappears if you press (OFF) for 2 seconds.
tPress (OFF) again for 2 seconds to display the clock. •Remove the front panel and clean the connectors. See
“Cleaning the connectors” (page 40) for details.
No beep soundThe beep sound is canceled (page 35).
Stored stations and correct time The leads are not matched correctly with the car’s accessory
are erased. | power connector. |
The fuse has blown.
Makes noise when the ignition key is in the ON, ACC, or OFF position.
No power is being supplied to The car does not have an ACC position. the unit.
The power is continuously supplied to the unit.
The power antenna does not The power antenna does not have a relay box. extend.
44