3While pressing the SCROLL button, press the COMPONENT select button or Label select button to which the desired Component
Macro has been programmed.
“MACRO” and the selected A/V component name appear on the first line and the programmed steps are listed on the screen.
4Press the V/v buttons so that the position of the delay appears in the third line on the screen, then press the
SCROLL button.
Delay is added between the second line and the third line on the screen, and “[DELAY]” appears in the third line on the screen.
5Press the OK button or centre
Label select button.
A beep sounds and programming is complete.
6Press the
(light) button or the RETURN button twice.
The set mode closes, and the Remote Commander returns to standby for operating the A/V components.
Notes
•If remote sensors of A/V components are too far apart from each other, or they are covered, consecutive operation steps programmed on a Component Macro may not be executed.
•If a Component Macro is not executed properly for any reason, such as mentioned above, be sure to set all the A/V components to the status before the Component Macro was executed. Otherwise, A/V components will not work properly next time the Component Macro is executed.
•Because some A/V components are designed to turn on/off each time they receive the power on/off signal, those components may not be turned on with the Component Macro. Check the power on/off status of the A/V components before using the Component Macro.
Clearing programmed steps of a Component Macro
If you make a mistake in programming steps or you want to programme a new Component Macro, follow the procedure below to clear the Component Macro.
1While pressing the
(light) button, press the OTHER button.
“SET MODE” appears as the screen title.
2Press the V/v buttons to select “4 MACRO”, then press the OK button or the centre
Label select button.
“MACRO” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
3While pressing the COMPONENT select button or Label select button on which the Component Macro has been programmed, press
the | (light) button. |
A beep sounds and the Component Macro is cleared.
4Press the
(light) button or the RETURN button twice.
The set mode closes, and the Remote Commander returns to standby for operating the A/V components.