Using the Series of
Commands
(Component Macro)
You can set an operation programme consisting of up to 32 steps (Component Macro) on the COMPONENT select button or Label select button corresponding to any component.
For example, when you watch a DVD by connecting a TV and DVD recorder to an amplifier, a series of operations like the ones below are necessary.
1Turn on the TV.
2Turn on the DVD recorder.
3 Turn on the amplifier.
4 Select the appropriate video input on the TV to watch the DVD.
5 Select the appropriate audio input on the amplifier to watch the DVD.
6 Start playing the DVD recorder.
The Component Macro enables you to perform these steps by holding down one of the COMPONENT select buttons or Label select buttons for over 2 seconds.
Programming a
Component Macro
Follow the procedure below to programme a Component Macro. You can programme up to 32 consecutive actions.
Example: To programme the procedure above to the DVD button1While pressing the
(light) button, press the OTHER button.
“SET MODE” appears as the screen title.
2Press the V/v buttons to select “4 MACRO”, then press the OK button or the centre
Label select button.
“MACRO” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
3Press the DVD button.
“MACRO DVD” appears as the screen title.
Tip
To select A/V components which are not set to the COMPONENT select buttons, press the OTHER button repeatedly, then press the Label select button corresponding to the desired A/V component displayed on the screen.
4Press the TV button, then press the 1 (power) button.