5Press the DVD button, the press the 1 (power) button.

6Press the OTHER button repeatedly, press the Label select button corresponding to the amplifier, then press the 1 (power) button.

7Press the t (input select) button repeatedly to select the appropriate video input on the TV to watch the DVD.

8Press the input select button on the amplifier to select the appropriate audio input to watch the DVD.

9Press the DVD button, then press N.

10Press the(light) button.

A beep sounds and programming is complete.

11Press the(light) button or the RETURN button twice.

The set mode closes, and the Remote Commander returns to standby for operating the A/V components.

Notes

•If the procedure is interrupted at any point for over 60 seconds, programming is cancelled. You cannot continue from where you left off.

•If you try to programme actions on a button that already has a programmed Component Macro, a beep sounds twice to alert you that you cannot programme a Component Macro on the button. In such a case, clear the programmed Component Macro (page 20), then start programming again from step 1.

•You cannot clear steps during the programming procedure. If you make a mistake in programming actions, finish programming once and clear the Component Macro (page 20), then start again from step 1.

•You can programme up to 32 consecutive operation actions. When up to 32 steps are programmed, programming of the Component Macro is full. To change the programmed steps, clear the Component Macro (page 20), then start over from step 1.

Checking if a Component

Macro is executed properly

Follow the procedure below to check if the programmed Component Macro works as intended.

To execute a ComponentMacro

1Press and hold the COMPONENT select button on which the desired Component Macro has been programmed for over 2

seconds.

The signal transmission icon appears on the screen, and the programmed Component Macro is executed.

Tip

While the signal transmission icon ( ) appears and the Component Macro is executed, “CANCEL” appears in the third line of the screen. You can cancel executing the Component Macro by pressing the right Label select button.

To check the programmed steps of a Component Macro and add a delay action

Delay action allows you to set an interval between steps. Delay time is set to 250 ms. (1/4 second) on the Remote Commander.

If a Component Macro is not executed as intended, check the programmed steps and try adding a delay to execute the programme properly.

1While pressing the(light) button, press the OTHER button.

“SET MODE” appears as the screen title.

2Press the V/v buttons to select “4 MACRO”, then press the OK button or the centre

Label select button.

“MACRO” appears as the screen title.

Tip

If a number is displayed before the menu, you can select the menu by pressing the number button.

Continued 19GB