The volume control buttons (2 +/- and %) of the Remote Commander are factory preset to control the volume based on the assumption that you hear the sound of your visual components from your TV speakers, and that you hear sound of your audio components from the loudspeakers connected to your amplifier.
The remote control signal transmitted by pressing the volume control buttons are factory preset as follows:
Visual component: Transmits the signal to control the volume of a TV. Audio component: Transmits the signal to control the volume of an amplifier.
For example, to control the volume while using a DVD player, you do not need to select the TV to control the TV volume. If an amplifier is connected to visual components, change the volume control setting of all the visual components to control the volume of the amplifier.
1While pressing the
(light) button, press the OTHER button .
“SET MODE” appears as the screen title.
3Press the V/v buttons to select “3 AUDIO SETTING”, then press the OK button or centre
Label select button.
“AUDIO SETTING” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
4Press the b button or right
Label select button.
A beep sounds and “AMP” is shown inside the [ ].
5Press the
(light) button or the RETURN button three times.
The set mode closes, and the Remote Commander returns to standby for operating the A/V components.
To reset the settings
Press the B button or the left Label select button in step 4.
2Press the V/v buttons to select “6 UTILITY”, then press the OK button or the
centre Label select button.
“UTILITY” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.