ProblemSolution
A Component Macro does not function correctly.
•When programming a Component Macro, programme the actions in the correct order (page 18).
•Change the direction of the Remote Commander. If it does not improve, position the Remote Commander closer to each A/V component.
•Check that the programmed A/V components are ready to receive the signals correctly (page 18).
•If you changed the preset code or programmed remote signals after programming the Component Macro, the new signal will be transmitted when executing the Component Macro.
•The interval between programmed steps is too short. See “To check the programmed steps of a Component Macro and add a delay action” (page 19) to extend the interval, or change the order of the steps.
The display turns off | The Remote Commander is preset at the factory to turn off |
automatically. | the display automatically if you do not operate it for over |
| 30 seconds |
| |
|
|
The set mode closes unexpectedly while setting.
The set mode closes if you do not operate the Remote Commander for over 60 seconds. Perform the next step within 60 seconds.
The confirmation beep does not sound.
Beep sound is set to off. Set it on (page 27).
The confirmation beep sounds even though beep sound is set to off.
A confirmation beep sounds during set mode, even if the beep sound is set to off.
“E” appears in the screen. | The batteries are weak. Replace them with new ones. |
The Remote Commander does not | If “E” appears on the screen, the Remote Commander |
enter set mode. | cannot enter into the set mode. Replace the batteries with |
| new ones. |
|
|