Setting the display
You can change the setting of the display. The Remote Commander is preset at the factory to turn off the display automatically if you do not operate it within 30 seconds. You can also change the brightness of the display.
1 While pressing the (light) button, press the OTHER button.
“SET MODE” appears as the screen title.
2Press the V/v buttons to select “5 UNIT SETTINGS”, then press the OK button or
the centre Label select button.
“UNIT SETTINGS” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
3Press the V/v buttons to select “5 DISP. OFF TIME”, then press the OK button or the
centre Label select button.
“DISP. OFF TIME” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
4Press the B/b buttons or the left or right Label select
button.
You can set the
5 Press the (light) button, centre Label select button, the OK button, or the RETURN button.
“UNIT SETTINGS” appears as the screen title.
6Press the V/v buttons to select “6 DISP. BRIGHTNESS”, then press the OK button or
the centre Label select button.
“DISP. BRIGHTNESS” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
7Press the B/b buttons or the left or right Label select
button.
You can set the brightness from 1 to 3. Each time the button is pressed, the level decreases/increases by 1.
8 Press the (light) button or the RETURN button three times.
The set mode closes, and the Remote Commander returns to standby for operating the A/V components.