Editing
Recording from another VCR or LD player
EDIT VHS | VIDEO |
PPAUSE | rREC |
Tips
•To cut out unwanted
scenes while editing, press P PAUSE on the unit when an unwanted
scene begins. When it ends, press PPAUSE again to resume recording (Assemble Editing).
•You can record audio sound from the desired input source on the video tape by pressing AUDIO repeatedly in step 4.
Note
•If you follow this procedure to start recording, the unit’s VCR won’t record with the APC function. To record a
tape with the APC function, press r REC again during recording pause in step 2 so the unit’s VCR analyses the tape. Then when you start
recording in step 6, press PPAUSE after the APC
indicator stops flashing. If you press PPAUSE before the APC indicator stops flashing, the APC function is cancelled.
Before you start editing
•Connect another VCR or LD player to the unit referring to the connections on pages 8 and 9.
•Press VHS TUNER.
–If the TV doesn’t turn on, turn it on manually.
–If connected with only the antenna cable, set the TV to the video channel.
•Press TAPE SPEED to select the tape speed, SP or EP.
•On this unit, set the EDIT switch to ON. If the other VCR has a similar switch, set it to ON as well.
•Do not use the remote commander in the following procedure.
1 Insert a tape with its safety tab in place into the unit (recording VCR).
Search for the point to start recording and press P PAUSE.
2 Press r REC on the unit to set it to recording pause.
3 • Insert a source tape with its safety tab removed into the other (playback) VCR when recording from another VCR.
•Insert an LD into the LD player, when recording from an LD player.
4 Press VIDEO or VHS repeatedly to select the input (playback) source (VIDEO1, VIDEO2, or LINE).
5 Search for the point to start playback and set it to playback pause.
6 To start editing, press P PAUSE on this unit and release the pause mode on the other equipment at the same time.
To stop editing
Press the pSTOP buttons on both units.
90 Editing