Specifications

System

Channel coverage

VHF 2 to 13 UHF 14 to 69

CATV A-8 to A-1, A to W, W+1 to W+84

Antenna

75-ohm antenna terminal for VHF/

UHF

VCR Inputs and outputs

VIDEO 1 IN

VIDEO 2 INPUT

LINE IN

VIDEO IN, phono jack (1) Input signal: 1 Vp-p, 75 ohms, unbalanced, sync negative AUDIO IN, phono jacks (2) Input level: 327 mVrms Input impedance: more than 47 kilohms

MONITOR VIDEO OUT

Phono jack (1)

Output signal: 1 Vp-p, 75 ohm (unbalanced), sync negative

TV IN

VIDEO IN, phono jack (1) Input signal: 1 Vp-p, 75 ohms, unbalanced, sync negative AUDIO IN, phono jack (2) Input level: 327 mVrms Input impedance: more than 47 kilohms

Amplifier

USA model:

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION

With 8-ohm load, both channels driven, from 20-20,000 Hz, rated 80 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.

Power output

Canadian model:

Stereo mode (8 ohms at 20 Hz - 20 kHz less than 0.09% total harmonic distortion)

70 W + 70 W

Surround mode

USA model:

(8 ohms at 1 kHz, THD 0.8%)

Front

80 W/ch

Center

80 W

 

(only in the PRO LOGIC

 

and THEATER mode)

Rear

80 W

Dynamic power output

8 ohms: 125 W + 125 W

4 ohms: 165 W + 165 W

Canadian model:

(8 ohms at 1 kHz, THD 0.8%)

Front

70 W/ch

Center

70 W

 

(only in the PRO LOGIC

 

and THEATER mode)

Rear

70 W

Dynamic power output

8 ohms: 95 W + 95 W

4 ohms: 130 W + 130 W

Frequency response

CD, TAPE/MD, VIDEO 1, VIDEO 2, TV, and LINE : 10 Hz - 50 kHz ± 1 dB

Inputs

CD

 

Sensitivity

220 mV

Impedance

50 kilohms

S/N

82 dB,

(Weighting

82 dB (’78 IHF)

network, input

(A, 0.5 V)

level)

 

TAPE/MD, VIDEO1, VIDEO2, TV,

and LINE

 

Sensitivity

180 mV

Impedance

50 kilohms

S/N

82 dB,

(Weighting

82 dB (’78 IHF)

network, input

(A, 0.5 V)

level)

 

Outputs

TAPE/MD REC OUT

Voltage 180 mV, Impedance 10 kilohms

MIX AUDIO OUT

Voltage : 2 V

Impedance : 10 kilohms

PHONES

Accepts low and high impedance headphones

Muting

–20 dB

BASS BOOST

+10 dB at 70 Hz

TONE

±8 dB at 100 Hz and 10 kHz

FM tuner section

Tuning range

87.5- 108.0 MHz

Antenna terminal

75 ohms, unbalanced

AM tuner section

Tuning range

With 10 kHz interval**: 530 - 1710 kHz

With 9 kHz interval: 531 - 1710 kHz

Antenna Loop antenna

**You can change the AM tuning interval to 9 kHz. After turning in any AM station, turn off the power, hold down the FM/AM button and press the POWER switch. To reset the interval to 10 kHz, repeat the

prodecure.

General

Power requirements

120 V AC, 60 Hz

Power consumption

190W

AC outlet

Switched 120 W / 1A MAX

Operating temperature

5°C to 40°C

Storage temperature

–20°C to 60°C

Dimensions

Approx. 430 ⋅ 157 ⋅ 430 mm (17 ⋅ 61/4 ⋅ 17 inches) (w/h/d) including projecting parts and controls

Mass

USA model:

Approx. 13.3 kg (29 lb 6 oz)

Canadian model:

Approx. 13.0 kg (28 lb 11 oz)

Supplied accessories

Remote commander (1) Size AA (R6) batteries (2)

75-ohm coaxial cable with F-type connectors (1)

Video cable (1 phono to 1 phono) (1) AM loop antenna (1)

FM wire antenna (1)

Design and specifications are subject to change without notice.

Additional Information

97