Camera the Administrating

Interval

Select an interval between 1 and 24 hours at which you want to adjust the camera’s time referring to the NTP server’s time. The set interval is a guide, and does not indicate the exact time.

Note

The setting time may not match with the exact time according to the network environment.

Time zone

Set the time difference from Greenwich Mean Time in the area where the camera is installed.

Select the time zone in the area where the camera is installed from the drop-down list.

Automatically adjust clock for daylight saving time changes

When you select it, the clock is automatically adjusted according to the daylight saving time of the selected time zone.

Note

If the time zone selected in Time zone is different from that set on the computer, the time is adjusted using the time zone difference and set on the camera.

OK/Cancel

See “Buttons common to every menu” on page 30.

Initialize TabReboot

Reboots the camera.

Click Reboot, and the message “The Camera will be rebooted. Are you sure?” appears. Click OK to reboot the camera. It takes about two minutes to start again.

Factory default

Resets the camera to the factory settings.

Click Factory default, and the message “Setup data will be initialized. Are you sure?” appears. When you click OK, the network indicator on the camera starts to blink. After adjustments of the default settings have finished, the camera reboots automatically. Do not turn off the camera until the camera reboots.

Tip

The camera can also be reset to the factory settings by turning on the power of this unit while pressing the reset switch on the camera. For details, see the supplied Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.

Click Save, and follow the instructions on the browser to specify the folder and save the setting data of the camera. The file name preset at the factory is “snc- rz50.cfg.”

Restore setting

Loads the stored setting data of the camera.

Click Browse and select the file in which the setting data is stored. Then, click OK, and the camera is adjusted according to the loaded data and restarted.

Restore preset position data

When you select it, the stored setting data of the camera and the preset position data are loaded.

Notes

•With Restore setting, some items in the Network menu (page 41) cannot be restored.

•When Restore preset position data is selected, it may take a long time to load the setting data.

Format CF memory card

Click Format to format the CF memory card (not supplied) inserted into the CF card slot of the camera. The files and folders stored in the CF memory card are deleted while formatting.

Format ATA memory card

Click Format to format the ATA memory card (not supplied) inserted into the PC card slot of the camera. The files and folders stored in the ATA memory card are deleted while formatting.

Notes

•Before formatting, disable the image memory function and the FTP server function to protect the CF memory card or ATA memory card against writing.

34 Configuring the System — System Menu