Using the SNC audio upload tool

When you start the SNC audio upload tool, the following window is displayed.

Audio upload tab

Use this menu to transmit audio from the computer to the camera.

Before transmitting, set Audio upload to Enable on the Common tab of the Camera menu.

Sound adjustment and indicators

Adjust the microphone input volume by moving the

slide bar. You can adjust the volume even during transmission.

Click to enable/disable sound muting. The microphone input volume is displayed at the Level. The transmission rate is displayed in the Bitrate box.

Voice alert tab

Use this menu to record the sound through the microphone connected to the computer and upload the recorded audio file to the camera.

Others

N(start)/x(stop)

Click N (start) to start audio transmission. The transmission speed is displayed in the Bitrate box during transmission. You can adjust the microphone volume and enable/disable the muting, if necessary.

To stop the audio transmission, click x(stop).

Note

If you change Proxy Address, Proxy Port, Codec on the Setting tab during an audio transmission, the changed settings will become effective after the transmission.

Recording/playback progress bar

You can check recording or playback progress with this bar.

During recording, the right end of the bar represents 30 seconds and the remaining recording time is displayed below the bar.

During playback, the maximum time of the bar depends on the recorded time.

(playback)

To start playback, open the recorded file or another audio file and click this icon.

You can check the recorded sound or the contents of the selected audio file. During playback, the progress bar shows playback progress.

76 Using the SNC audio upload tool — Transmitting Audio to Camera